Washington Post: Americans waste $10 billion each year on name-brand ink. So we tested low-cost options including remanufactured cartridges, ink injection kits — and even making our own.
My advice: get a mono laser printer. Printing is handy but relatively infrequent for a lot of people these days. If that’s your use case, mono laser is the way to go. Toner does not dry out or go bad.
I use my HP printer infrequently enough that every time I booted up my inkjet, I had to put it through a printer head cleaning cycle. I’d be surprised if I got more than 20 sheets of paper for each cartridge do to the wasted ink, and the dang thing malfunctioned frequently even after cleaning (streaks, blots, complaining about missing colors when printing b/w, etc).
After switching to a Brother mono laser, I haven’t had to do any maintenance in 3 years and it’s still on the original toner cart which it came with.
This is the way.
Also using a Brother laserjet, it’s lasted ten times longer than any inkjet I’ve ever had, and still going strong. Although I rarely need to print, it hasn’t failed me yet when I do need it.
This is the way.
Print at work.
If you can’t, print at an office supply store.
Seriously, how much do you need to print?
You can also print at a library in the US
Print. At. Your. Local. Library.
Not. Everyone. Has. Easy. Access. To. A. Local. Library.
😞
Printing on a printer that isn’t yours is a privacy risk.
IMHO, inkjet printers as a whole are a scam. That is, unless you buy a really high end one for professional photo printing.
From 15 years of experience in IT, and with home printing:
Many inkjet printer manufacturers will refuse to print if you insert non-oem cartridges. Just because one model will allow you to dismiss a warning doesn’t mean they all will. I’ve seen people waste a lot of money doing this.
The ink injections are also tricky. What I’ve seen is that the ink ends up leaking all over the inside of your printer, or worse, the printer will refuse to print it because it knows it’s been tampered with.
Also, unless you have a specific use case for an inkjet (design work, photo prints, etc), just get a cheap laser. Or if you don’t print that much, just throw your documents on a flash drive and go to your local office supply store. Or library.
As for re-manufactured cartridges, especially for laser: stay away. I’ve seen them time and time and time and time again burst in the printer and spill toner all over the place. This kills the machine. So the $50 you might save on a cartridge will end up costing you hundreds or thousands in the long run.
The whole damned industry is predatory, built for lock-in, and designed to fuck you over. It really sucks. But there’s no reliable way around it.
What are your thoughts on ink tank printers?
I haven’t had much experience with them. Seems like they never got very popular
I love my mono laser printer. It’s an older Canon I got from a retired lawyer, so it has probably printed a million pages already for all I know. Haven’t had to futz with it since I popped in a new toner cartridge that was ~$40. If I need to print color, I go to the local copy store, but that’s rare anyways. Been recommending the same for all my friends and family.
I have a Brother laser printer that works fine since undergrad. $100, almost 15 years ago. Good colors still, but it came with this thing where you have to block it at the firewall from the Internet so it doesn’t spy on you (something about reporting to Amazon servers?) and it will pretend that your toner is low on purpose, but you can cover up the sensor with electrical tape and it works fine. Prints with Linux, BSD.
I also have a Canon inkjet. I was on a trip and needed a printer and … $25 dollars out of pocket, I ended up with a device that has scanning and color printing and works with Linux. Five years later and it still works, although the aftermarket cartridges I use are $33, more than the printer itself cost. There’s no DRM making me buy just Canon ink. Works with Linux.
After reading that Epson was getting out of the laser printer business altogether for environmental reasons, I called BS on it. Likely a reason for them to sell nothing but DRM’d junk inkjets that are even more wasteful because they break every other year.
But the truth is somewhere in the middle.
Laser printers are also horrible for the environment. The fusers and toner cartridges cannot be recycled and the toner itself is nothing but microplastic that never breaks down.
I hope to never buy a printer again. Fuck that anymore, It’s the 21st century, I have a PDF editor and a tablet.
This is good to know. I had no idea toner is so bad for the environment. It’s yet another reason to use ink tank printers.
There are also lots of knock off cartridges for most laser printers too.
I have a brother laser printer copier - it works with budget cartridges that cost around $25.
Another for the get a laser printer train, I got a Xerox color laser printer 8 years ago for a ridiculously good deal (like $130). I finally had to replace the original toner last year, and it took my off brand cartridges just fine at a cost of like $50 for the full set of four. Came with Linux drivers even! Having color is nice too, means I don’t have to think about using another printer. We keep my boyfriend’s inkjet printer around solely for scanning things at this point.
One caveat: there were some reports of health effects of inhaling toner fumes, so make sure wherever you keep your laser printer is reasonably ventilated.
Commercial printer here! There’s some validity here, but health risks for at-home printing would be minimal in my opinion unless someone is printing a lot. Toner machines tend to release ozone from the corona wires that are used to charge the drums.
Toner machines tend to release ozone from the corona wires that are used to charge the drums.
I’m doing my part to plug that hole in the ozone layer!
There is a safety concern that you shouldn’t clean anything involving toner with ammonia-based products (window cleaners, etc.) It reacts with the plastic in the toner. Isopropyl alcohol can be mixed with a smaller ratio of water to use as a cleaner. I do agree with the original message and always recommend people buy laser over inkjet for most tasks.
Some of you should try ink tank printers. Low ink prices and lots of ink in each refill. They come out of the box with thousands of pages worth if ink! Only problem is they sometimes get clogged.
Glad someone made this point. My next printer will definitely be a tank printer. It’s basically flipping the business proposal back to “pay for the printer up front” instead of “pay for the printer whenever you buy ink”. My current printer was cheap enough that I basically spend enough on ink to buy a new printer every few years, given degradation of cartridges when they’re left after opening.
Some of you should try
I think by “some of you” you mean “heavy printer users”, and if so I agree.
The typical use case for most folks is infrequent (maybe print 100 pages 1 month and 1 page each month otherwise or less) and works when you want to use it.
The two features you describe do add value, but are anti features when an in
- lots of ink paying for more than you need
- sometimes gets clogged
lots of ink paying for more than you need
You pay less for an ink refil on an ink tank printer than you do a toner refil for a laser printer. This is despite the fact that the ink refil lasts longer.
I agree with the idea that infrequent users should consider laser printers. The main issue I have with them though is the cost. A colour laser printer is more expensive than even a tank printer which is expensive to begin with. It also can’t do photos very well which is something a lot of people use printers for. Greyscale laser printers are only good for text.
I’ve got a Canon Pixima 5000 series. My family tends to print a good percentage in color (because thankfully I don’t have to print many documents in this day and age). It uses individual color cartridges (C, M, Y, K and a second large K), so if one goes out you just replace that color. I generally pick up the off brand refills on Amazon for fairly cheap. Last time I got a 5 pack of sets for $20. It’s lasted us 2 years at this point. The ink carts are literally JUST ink and a foam block. No electronics or drm like HP. Highly recommend.
Been on the laser printer bandwagon for almost 10 years. Bought a mono Samsung and it’s been my ride or die ever since. I think I’ve gone through two toners in that time, maybe 3. My only regret is not getting a color one but that’ll be my upgrade if this one ever dies.
HP bought the Samsung printing business and kinda ruined it FYI. If it ever breaks, you have my condolences.
Can’t say I’m surprised by that. I’ve seen Brother highly recommended so the future isn’t too bleak if I can’t get another one ☺
If you have a small space and don’t print a lot, I love my thermal printer. It’s the size of a sturdy, old-fashioned 3-hole-punch. Portable and battery-operated. There is no ink. The special paper’s kind of expensive, but it doesn’t dry out or send you codes saying you can’t print when it obviously can. And they make BPA-free thermal paper now.
Absolutely, I got inkjet printers for years between ~1990 and ~2010, ink is expensive, dry, smear, etc. I bought a Samsung color laser wifi printer in 2012, more than 10 years ago, I changed toners a few times, it still work perfectly fine. I’ll never again go to inkjet.
Lasers are definitely a great option, but we got a printer with liquid ink and it’s been great. Much cheaper than proprietary cartridges and they don’t go stale if you don’t print anything for a few weeks.
